HK-8SS-L Carro leve de soldagem automática com alimentador de arame para solda de filete

Constituição

HK-8SS-L is made up of carriage body, guide wheel, control box. Regulating mobile seat, welding gun holder, welding gun wiggle

1 Carriage body: It is the skeleton of the whole machine, and the supporter of the other parts. It is equipped with the driving mechanism, which is installed in the body cavity of the carriage, through the reducer casing to achieve carriage’s four-wheel drive.

2 Electromagnetic valve (DC24V).

3 Wire feeder interface

4 Wiggler interface

5 Carriage’s power supply interface

6 Wire feeding mechanism

7 Control box: can control carriage’s all functions and details refer to "control panel introduction".

8 bobina de fio

9 Welding gun cable bracket: It is a device for fixing the welding gun cable; for the convenience of welding gun, the screw type cable clip is adopted.

10   Stand column: it is used to support the wire reel and the cable bracket.

11 Wire reel shaft holder: it is used to adjust the position of the wire reel; after confirming the position you should tighten lock screw.

12 Anti-dropping locating clip: before adjusting the wire reel, be sure to lock the holder, to prevent the wire reel falling and smashing other parts.

13 Welding gun wiggler: guidance for all kinds of swing mode welding. Wiggler output shaft end is tightly near to the welding gun angle adjustment device. It can easily and accurately make the gun center on the weld and fine adjust the angle of gun. Finally connected to the welding gun holder, which is a holding device, you can easily repair, adjust, and demount the gun.

14 Regulating moving seat (up and down): as a device to regulate the location of welding gun, if the welding gun deviated from weld pass, the welding gun can be adjusted up and down.

15  Guide device: the guide wheel along the guide rail profile to roll, to guide the precise welding position. When installing the guide bar, subject to the walking direction, the back guide bar should extend length of 3 ~ 5 mm long than the front guide bar.

16 Regulating moving seat (leftward and rightward): as a device to regulate the location of welding gun, during welding it can be adjusted leftward and rightward.