logo
  • HK-5E chariot de soudage automatique portable à deux torches
  • HK-5E chariot de soudage automatique portable à deux torches
  • HK-5E chariot de soudage automatique portable à deux torches
  • HK-5E chariot de soudage automatique portable à deux torches
  • Nom du modèle:

    HK-5E chariot de soudage automatique portable à deux torches

  • Déscription
  • Small capacity, low gravity center, lightweight, portable.High magnetism magnet increases dependability of operating and draft load to assure the machine operates smoothly. You can operate many machines on the base of increase dependability of operating and self-stop function.The guide transfer switch can make it move toward right/left.Guide equipment is screw lockage-on type.

Suivez-nous:

Name and function of each section

1) Adjusting gliding block of torch

You can use this equipment to adjust arc starting point toward up/down, front/rear. Each distance of run is 60mm.

2) Spacing switch

There are spacing switches on both ends.

If you put an impulse force to switch, it may be damaged. When the autostop switch is broken, the function of it will vanish.

3)Guide wheel: The guide wheel should stick to plate when welding.

You must assemble the guide wheel correctly, else it may lead to failure of spacing switch.

4)Thermal baffle

5)Blowtorch

6)Body of tractor

7)Torch locking: Make sure you lock the torch.

If you tighten the current-carrying part, it may lead to short or electricshock.

8)Handle knob: Hold the knob when you carry it.

9)Operating panel( illustration in full in after chapters)

10)Electric box

11)Metal plug

This plug is external plug.

12)The cable is used to connect carriage with feeder and provide power for them.

(There are two branches, one connecting feeder and another connecting power.)

Caractéristiques

1. Poids

9 Kg

2. Driving method

Four rubber rims driving

3. Hauling power

30 Kg

4. Vitesse de course

50~1500 (mm/min)

5. Tracking mode

Guide wheel type

6.range of torch

1)Rotating angle: 360°

2)Up /down moving:60 mm

3)Front/rear moving: 60 mm

8. Locked equipment of torch

Suit for bended welding torch or straight welding torch

9. Needed welding length

Front-end:60 mm    end:60 mm

10. Self-stop function

By spacing parts of front-end and after end.

11.Size(length*width*height)

320 mm x280 mm x290 mm

Liste des forfaits

Le contenu de l'emballage standard est indiqué ci-dessous. Vérifiez-les attentivement avant de monter la machine.

1.host machine

1set

2. control wire 

1pc

3. fuse(1A)

1set

4.inner hexangular screw

1set

5. manuel   

1pc

6. certificate of qualification

1pc

Notice: special torch (option parts) need be purchased by user.

haut
© Copyright : Shanghai Huawei Welding & Cutting Machine Co., Ltd.. Tous droits réservés. - Politique de confidentialité | Conditions générales

Si vous avez des questions, veuillez envoyer une demande par e-mail